Material choose type of material closest to the vinyl you will be using.
Kiss cut vinyl silhouette settings.
Press the flashing go button.
Set your media size to the exact size of material you re using.
Clicking on vinyl in material settings tells us that we need to use all the platforms 2 2 1 mat.
Place adhesive foil shiny liner side down onto stronggrip mat.
Within the page setup panel select none from the cutting mat drop down menu just as we did with the kiss cut option.
8 force.
If my blade is on the dull side like now i use a blade depth of 2 but if i.
In the video i used the default cut settings for the silhouette brand white sticker paper blade depth.
This will get you to a good starting point.
14 single pass but the online labels sticker paper that i use is a little bit thinner than the silhouette brand.
You need to make sure you text cut every time you change vinyl to avoid wasting materials.
Continue to the charts below to find the cut settings for kiss cut and full cut stickers using your autoblade and ratchet blade.
I was so excited to see that expressions vinyl made this little cheat sheet chart.
Select images and size and load mat into the machine.
Refer to kiss cut guide table below to adjust machine settings a kiss cut goes through the vinyl film and leaves the liner intact.
Our expert crafters have hand tested the silhouette cameo 3 with onlinelabels sticker paper to bring you the exact cut settings for each material.
This can be soooo annoying.
That will open up a whole new screen that is chock full of information.
Then once your machine has cut a square you unload from the machine and check to see whether it has cut through the first piece but not the backing and at one point it will have done just that and there are the perfect cut settings for that type of paper with your silhouette machine.
To find your settings click on the blade icon at the top of the screen to open cut settings.
Image via okay this is awesome.
2 speed.
Once you have arrived at the send tab this is where you can change your settings.
Within the send panel select your material type.
You can access the cut settings by clicking on the send tab in silhouette studio.
